KaCompact KG
Ventilation unit with heat recovery to replace polluted air with fresh outside air.
- Heating
- Cooling
- Ventilation
Stand-alone control variant
System control variant
Each of the KaCompact KG units has a defined, ErP-compliant power range. Generous overlaps in the operating range enable a targeted selection, either cost-optimized or with a power reserve.
The choice of the required air volume flow determines the model size to be selected, taking into account the efficiency values of the ErP Directive.
| max. air volume |
|---|
| 1500 m³/h |
| 2500 m³/h |
| 4000 m³/h |
| 6000 m³/h |
Both horizontal and vertical air duct connections are available for air duct routing in order to be able to react to on-site conditions.
| air duct connection |
|---|
| horizontal |
| vertical |
Various water-based coils are available for possible post-tempering of the supply air. The heating coil is used exclusively for heating, the cooling coil can be used as a change-over coil for heating or cooling.
In the case of horizontal units, the change-over register is inserted in an external cube.
| coil design |
|---|
| with change-over register |
| with heating register |
| without register |
Depending on the structural conditions and installation requirements, the exhaust air connection can be located either on the left or right side of the unit.
The connection side is defined from the perspective of the mounted unit.
| extract air side |
|---|
| left |
| right |
For system units in combination with e.g. secondary air units, the KaCompact KG is available with pre-installed control, sensors and actuators.
Once the power supply has been established, the unit is ready for operation.
For on-site control, all sensors and actuators are wired to a central terminal strip in the control housing for convenient connection.
| Control option |
|---|
| electromechanical |
| stand-alone control |
Results per page
Results per page
Page 1 of 0
Results per page
Results per page
Page 1 of 0